Sod Calculator

Laying a new lawn? Enter its size to see how many square feet, pieces and pallets of sod to order.

Updated Nov 2026 Formula shown below Feet or meters
ft
Enter a number (0 or more)
ft
Enter a number (0 or more)
5%
sq ft
Enter a number (0 or more)
Your prices (optional)
$/ sq ft
Enter a number (0 or more)
You'll need
–
greener on your side ✌

How to calculate how much sod you need

Sod is sold by area. Multiply the length and width of your lawn in feet to get square feet, then add a little extra for trimming around edges, beds and curves. Divide the total by the size of one piece to count slabs or rolls, and by the coverage of a pallet to see how many pallets to order.

Sod (sq ft) = Length (ft) × Width (ft) × (1 + Waste % ÷ 100)

For an L-shaped or irregular yard, split it into rectangles, work out each one and add them together. A 16 × 24 inch slab covers about 2.67 sq ft, an 18 × 24 inch slab covers 3 sq ft, and a 2 × 5 ft roll covers 10 sq ft. Slab size depends on the farm's sod cutter, so ask your supplier which one they sell.

Pro tip!

Order about 5% extra for a simple rectangle and closer to 10% for curvy beds, narrow strips or lots of trees. Running short mid-job leaves bare soil drying out while you wait for more.

Worked example: a 20 × 20 ft backyard lawn

Say you're replacing a patchy square of lawn, 20 feet on each side, with 16 × 24 inch slabs and 5% extra.

  1. Find the lawn area20 × 20 = 400 sq ft
  2. Add 5% for trimming400 × 1.05 = 420 sq ft
  3. Count the slabs420 ÷ 2.667 = 157.5 → 158 slabs
  4. Count the pallets420 ÷ 450 = 0.93 → 1 pallet

One 450 sq ft pallet covers it with about 30 sq ft to spare.

Sod piece and pallet sizes

Sizes vary by farm and grass type, but these are the most common.

PieceSizeCoversPer 450 sq ft pallet
Slab16 × 24 in (41 × 61 cm)2.67 sq ft (0.25 m²)About 169
Slab18 × 24 in (46 × 61 cm)3 sq ft (0.28 m²)150
Roll2 × 5 ft (0.61 × 1.52 m)10 sq ft (0.93 m²)45

Pallets typically hold 400–500 sq ft. Ask your supplier and enter their number above. Prices vary by region and grass type.

Prepping and laying sod

Good prep matters more than the sod itself. Clear the old grass and weeds, loosen the top few inches of soil, and mix in topsoil or compost where the ground is poor. Rake it smooth and level so the soil sits about an inch below paths and patios. That leaves room for the thickness of the sod.

Start along a straight edge, like a driveway or path. Push the pieces tight against each other and stagger the joints like bricks. Trim around curves with a sharp knife. Roll the lawn to press the roots into the soil, then water deeply right away. Keep the soil moist until the roots take hold, and stay off it as much as you can for the first couple of weeks.

Questions people ask

How many square feet are in a pallet of sod?

Usually 400–500 square feet, depending on the farm and the grass. Ask your supplier and enter their figure in the calculator.

How many pieces of sod do I need for 1,000 square feet?

About 375 slabs of 16 × 24 inches, or 100 rolls of 2 × 5 feet, before adding extra for trimming.

How much extra sod should I order?

About 5% is usually enough for a simple rectangle. Go up to 10% for curved beds, narrow strips or lots of obstacles.

Can I lay sod over existing grass?

It is not a good idea. The old grass keeps the new roots from reaching the soil. Remove it first, then loosen and level the soil before you lay the sod.

Sources

The numbers in this calculator come from these manufacturer specs and public guides. Always check the label on the product you buy.

  1. A pallet holds about 50 sq yd (450 sq ft); rolls 2 × 5 ft — Purdue Extension
  2. Pallets typically 450–500 sq ft; buy about 5% extra — Mississippi State Extension
Was this calculator helpful?

Fixing up the whole yard?

See all calculators